Emirates Scholar Research Center - Research Publishing & Indexing Center

DYNAMIC PATH GENERATION VIA LOAD MONITORING WITH A FORCE SENSOR FOR ROBOT PROCESSING USING A CHISEL

Authors: Yusuke Nakamura

Journal: 38th International Symposium On Automation And Robotics In Construction Dubai, UAE.

Publication Date:  Nov 2021.

Keywords: Robot Processing Dynamic Path Wood Carving Force Sensor


Abstract

Following A Static Path, Pre-Calculated As The Tool Trajectory, Cannot Reflect Potential Changing States During The Machining Process. Therefore, Adjusting To Environmental Differences Between The Assumed And Actual Conditions, Such As Variations In The Physical Properties Of The Material, Is Not Possible. In This Study, The Tool Path Was Dynamically Changed By Monitoring The Load Applied To The Tool During Processing. Furthermore, Applying Our Method To Processing With A Chisel Demonstrates That Parts Can Be Machined Appropriately Via Dynamic Path Generation.

Read full article

Join the Conversation

  1. I’m not sure why but this blog is loading incredibly
    slow for me. Is anyone else having this issue or is it a problem on my end?
    I’ll check back later and see if the problem
    still exists.

  2. A motivating discussion is worth comment. There’s no doubt
    that that you should publish more on this subject matter, it might not be a taboo matter but typically people do
    not discuss these subjects. To the next! Many thanks!!

Leave a Reply

Your email address will not be published. Required fields are marked *

Scroll to top
Close
Browse Tags